Solid wood furniture production process: woodworking production
Solid wood furniture processing technology is mainly the processing technology of solid wood parts. The process of solid wood parts refers to changing the shape, size, or physical properties of raw materials through various processing equipment. When the raw materials are processed into products that meet the technical requirements, the sum of a series of work carried out is called the technological process. It consists of several processes. Drying - Ingredients - Wool Fabrication - Gluing - Bending - Net Processing - Component Assembly - Component Processing - Assembly, Finishing. Second, carpentry 1. The wide sand is thick and thick, and the required size of sand conforms to the processing requirements. After the machine is finished, the sand is polished, and the coarse sand is 0.2 mm, and the polishing sand is 0.1 mm. 2. Fine cutting, fixed length of wool, no collapse, blackening during processing, long and wide processing error is not more than 0.2mm, diagonal below 1 meter ≤ 0.5mm, diagonal of sheet above 1m should be ≤ 1mm. 3. Forming, according to the drawings will be processed wood molding. No collapse, burr, knife jumping and blackening are allowed during processing. The surface of the machined components should be smooth, flat, and smooth. The pre-machining inspection should be performed with the screws of the equipment components loosened, and whether the template is installed or not, and whether the tool is tightened. During processing, it is forbidden to feed with the knife, and the size error of the part does not exceed 0.2mm. 4. Drilling, drilling according to the technical requirements of the drawings, no chipping, no thorns during the processing, the hole position processing error shall not exceed 0.2mm, the product must be matched with the drilling, often test installation, diligent inspection, ensure the product Quality. 5. Accessories sand, sanding accessories, sanding finished product should be smooth, no sand marks, corners consistent. Before the sand inspection, you should first understand the location of the parts to be used, sanding after the first soil fill. 6. The group shall set up and organize the parts that are not to be dismantled. Before the group is erected, it shall be stocked first. All the parts to be assembled shall be checked according to the requirements of the drawings and the parts shall be free from chipping, burrs and blackening. There is no error with the drawing process. During the assembly process, the glue coating is evenly applied and the semi-finished product is well-assembled. There should be no phenomenon of pinning or missing nails. The combination should be tight and the glue should be wiped clean. 7. Large-scale assembly, test assembly parts inspection and drawing errors. The difference with the group is that after the group is finished, it is the finished product. 8. The finished product is sand-sanded and the finished product is sanded to make it flat, without sand marks, and with uniform corners. 9. Balance, leave parts naturally for a while. 10. Paint the sand on the wire and re-sharpen the surface of the workpiece, especially on the surface of the wood. At the same time check whether the white body's defects have been handled properly, such as: poor repair, poor sanding, cracking, deformation and so on. 11. Dust blowing, blow dust off the surface of the workpiece. The company Sports Equipment Co., Ltd. mainly produces outdoor slides, kindergarten toys, children's furniture, outdoor equipment, kindergarten rubber mats, naughty castles, etc. It is a science and technology enterprise integrating design, production, sales, and after-sales services. Website:. Advisory telephone. The company's pleasure and dedication to serve you! Factory address: No. 16, Chuangqiang Road, Lucheng District, Wenzhou City Light Industry Park. Napkin Paper,Serviette Napkin,Bathroom Tissue Paper,Premier Tissue Paper DONGGUAN YEE HUP TRADING CO,.LTD , https://www.yeehupacks.com