Vibration test equipment advantages and precautions

Vibration test equipment is an experimental device that can simulate the vibration resistance of a product during its manufacture, transportation, and use. The vibration test equipment can help production and users find faults early and evaluate the seismic quality of products. What are the advantages and precautions of the vibration test equipment test? Kunshan Haida instrument details for you:

HD-521-2 vibration test equipment advantages:

1. The controller is easy to operate, completely closed and extremely safe.

2. High efficiency, high load, high frequency width, low failure.

3. When designing, it can analyze the damage points and easy points.

4. Mobile work base, easy to place, beautiful and generous.

5. When analyzing the quality, analyze the different points and bad points produced in each batch of products.

6. Electronic control, vibration frequency, amplitude adjustable, driving force, small noise.

7. During production, it can be measured while vibrating completely, so that the product defect rate can be found early.

8. Endurance measurement allows durable use of the product and early improvement of components that are not durable.

Vibration test equipment to do vibration test should pay attention to matters:

1. Check the power cord for damage

2. Placement environment: Suitable for normal temperature to below 45 °C and well ventilated and non-corrosive environment;

3. During the test, pay attention to safety. When you find an abnormality, do not panic. If necessary, turn off the main power supply.

4. Check the input voltage: pay attention to the phase balance and the power supply voltage fluctuation range can not be too large, the ground must be good;

5. The instrument can not be used to test products with volatile, fragile, explosive and corrosive gases;

6. The test piece must be rigidly installed on the test bench. Otherwise, resonance and waveform distortion will occur, which will affect the correct test of the test piece. In the vibration test of the test piece, it cannot be disassembled. If necessary, the machine must be shut down first.

7. The fixture used in the test should be used correctly and ensure it is fixed to avoid causing injury and equipment damage.

8. The system must not touch the sensor during operation.

9. When the vibration tester 'target=_blank> vibrating tester is working, do not place magnets or objects (such as watches) that do not come into contact with magnets near the vibration generator.

10. Absolutely not allowed to turn off the control box and microcomputer power before turning off the power amplifier, otherwise it will cause impact or even damage to the power amplifier and vibration table.